SIGNALBOOST amplifier, Dual Band 824-894 MHz and 1850-1990 MHz Cellular and PCS network Amplifier/ Booster model 811214 by Wilson Electronics:
SIGNALBOOST amplifier, Dual Band 824-894 MHz and 1850-1990 MHz Cellular and PCS network Amplifier/ Booster model 811214 by Wilson Electronics:
Plug-and-Play with included RF Inductance cradle, Cigarette lighter plug, 5 db magnet mount antenna works with all Cellular and PCS cell phones and networks Easy In-Home or Office booster for a single cell phone where 12 volt DC power is available
$189.95 US/ State Government Agency Purchase orders welcomed That's a Discount Savings of: $60.04
SIGNALBOOST amplifier, Dual Band 824-894 MHz and 1850-1990 MHz Cellular and PCS network Amplifier/ Booster model 811214 by Wilson Electronics is Plug-and-Play with RF Inductance cradle, cigarette lighter power plug and 5 dbi magnet mount antenna. SIGNALBOOST works with all Cellular and PCS cell phones and networks.
No plug-in cell phone adapter is needed: Connects to ALL cell phones up to 2.25 inches wide with the included cell phone cradle. The cradle has a 6 foot RF cable to connect into the inclluded RF amplifier.
Optional cell phone RF adapter cables are recommended whenever possible for superior transmission of signal. Connection on amplifier is an FME male connector. RF adapter needs to end in an FME female connector, many folks use the ACC-6 RF adapter to mate with Wilson RF adapter cables.
Wilson Electronics SIGNALBOOST Dual Band amplifier/ booster has 10 times more power than your cell phone or laptop data card alone. This amplifier improves voice and data signal. 3G technologies often need the signal boost for data communications. This amplifier also reduces battery use on the cell phone.
12 volt DC Cigarette Lighter Plug and 12 foot antenna cable are included for an easy self installation in a vehicle.
Perfect in-home solution: Use RPS1203 12 volt power supply for in-home or in-building applications.
3 watts maximum output: Power control logic ensures maximum output power is within cellular standards, since Gain is cell site controlled.
Model W-811214 works on all Digital formats of CDMA, TDMA and GSM used in the Americas.
Note: Not compatible with iDen/ Nextel ESMR networks in the 800-824 MHz band.
Specifications: Max RF +35 dBm / +33 dBm. Noise Figure 3.5 dB nominal. Flatness 2 dB / 2 dB. Isolation (uplink/downlink) >50 dB. Power Requirements 12 Volts DC, 2 Amp minimum. Connectors on Amplifier are FME-Male and 50 ohms. Dimensions 5 x 3.5 x 1.2 (inches) / 12.7 x 8.9 x 3 (cm). Weight 1.03 pounds / 0.468 kilograms. Model Number W-811214 operates at both cellular radio frequency bands of 824-894 MHz and 1850-1990 MHz.
Use ACC-6 RF adapter to mate this amp with any Wilson RF adapter cable.
