SIGNALBOOST amplifier, Dual Band 800 MHz/ 1900 MHz Cellular and PCS network Amplifier/ Booster model 811214 replaces 811211 by Wilson Electronics:
Plug-and-Play with included Cigarette lighter plug, 5 db magnet mount antenna, and inductance cable/ cell phone cradle works with all Cellular and PCS cell phones, Data cards, and networks Easy In-Home or Office booster for a single cell phone or Data card where 12 volt DC power is available
$189.95 That's a Holiday Discount Savings of: $60.04
SIGNALBOOST amplifier, Dual Band 800 MHz/ 1900 MHz Cellular and PCS network Amplifier/ Booster model 811214 replaces 811211 by Wilson Electronics, and is Plug-and-Play with cigarette lighter plug and 5 db magnet mount antenna. SIGNALBOOST works with all Cellular and PCS cell phones, Data cards and networks.
No plug-in phone adapter is needed: Connects to ALL cell phones and data cards with either the included cell phone cradle or Velcro device. Simply place your cell phone into the inductance cradle. The cradle has a 6 foot RF cable to connect into the amplifier. Alternately glue one side of the Velcro to the antenna area of the cell phone/ Data card near the internal antenna at the top, and the other Velcro piece has an RF cable leading into the amplifier/ booster.
Optional cell phone RF adapter cables are recommended whenever possible for superior transmission of signal. Connection on amplifier is an FME male connector. RF adapter needs to end in an FME female connector, many folks use the ACC-6 RF adapter to mate with a TH Bury car kit.
Wilson Electronics SIGNALBOOST Dual Band amplifier/ booster has 10 times more power than your cell phone or laptop data card alone. This amplifier improves voice and data signal. 3G technologies often need the signal boost for data communications. This amplifier also reduces battery use on the cell phone.
12 volt DC Cigarette Lighter Plug and 12 foot antenna cable are included for an easy self installation.
3 watts maximum output: Power control logic ensures maximum output power is within cellular standards, since Gain is cell site controlled.
Model W-811214 works on all Digital formats of CDMA, TDMA and GSM used in the Americas.
Note: Not compatible with iDen/ Nextel ESMR networks in the 800-824 MHz band.
Works great in mobile, in-building and marine applications.
Specifications: Max RF +35 dBm / +33 dBm. Noise Figure 3.5 dB nominal. Flatness 2 dB / 2 dB. Isolation (uplink/downlink) >50 dB. Power Requirements 12 Volts DC, 2 Amp minimum. Connectors on Amplifier are FME-Male and 50 ohms. Dimensions 5 x 3.5 x 1.2 (inches) / 12.7 x 8.9 x 3 (cm). Weight 1.03 pounds / 0.468 kilograms. Model Number W-811214 operates at both cellular radio frequency bands of 824-894 MHz and 1850-1990 MHz.
Use ACC-6 RF adapter to mate this amp with any Wilson RF adapter cable.
FCC and IC type accepted. US and foreign Patents Pending.
Wilson Electronics factory original One year warranty applies.
